Best 10 Plumbing Tips Everyone Needs to Know


Best 10 Plumbing Tips

One of the most important aspects of being a homeowner is being able to take care of basic plumbing issues. Whether it’s fixing a leaking faucet or replacing a water heater, knowing how to fix basic plumbing problems can save you hundreds of dollars a year. This is especially true when it comes to gas or electric plumbing, which are much more complex than standard water pipes. In this post, we’ll cover 10 basic plumbing tips and tricks that everyone should know.

1. Know the Location of Shut-Off Valves

 Knowing what to shut off in an emergency is critical, yet many homeowners don’t know how to locate shut-off valves. In the case of plumbing, these are located under the sink and near toilets, showers, sinks, and bathtubs. Nobody wants to have to damage any part of their home’s plumbing system, but knowing how to shut off the water supply or stop a toilet from overflowing can help you avoid many major disasters.

2. Don’t Puncture Pipes

 Pipes can be the cause of many plumbing issues. Puncturing them can make things even worse. This article gives advice on the right way to unclog a drain or toilet without causing damage.

3. Find Out What’s Flushable

 Many of us don’t think much about our bathrooms, other than using the toilet or brushing our teeth. But when we’re not careful, you can find yourself with a clogged toilet or sink. Some bathroom items, such as cotton swabs, wipes, and even wet paper towels, cannot be flushed with your regular water. That’s bad news if you’re planning a plumbing disaster! Fortunately, you can find out what’s flushable for plumbing so you can keep your bathroom looking and working tip-top.

4. Don’t Put Garbage Down the Drain

 When objects end up going down the sink and into the pipes, it can wreak havoc. If only one pipe is blocked, this often causes problems for only one fixture, but if one pipe is blocked in two different fixtures, it can cause a major headache. If there is too much debris in the pipes, it can back up and overflow, causing the pipe to break and flooding to occur.

5. Take the Plunge

 It is likely that all households have some form of plumbing. Whether you fix your own plumbing or hire a professional such as VIPDrains Plumber in Sydney, this is a necessary part of life in the United States. Although plumbing can seem daunting, it’s important to remember that most people install or maintain their own plumbing. So, if you’re ever in need of help, don’t be afraid to call a professional.

6. Pull Out the Vacuum

 Want to save money on your utility bills? Spending some time vacuuming your home can identify any issues with your plumbing. Since we know how important your plumbing is to you, (and because we can help keep clean your home at no additional cost to you), we’re sharing some tips on how to find any potential plumbing issues and eliminate dust buildup and help avoid clogs.

7. Don’t Ignore Leaks

 Leaks are a common house issue. They can be caused by many reasons including old age, lack of maintenance, damaged pipes, or faulty fixtures. However, most leaks are preventable and can be easily fixed by following the steps below. When it comes to plumbing, fixing a leak sooner rather than later will save you money and prevent further damage to your plumbing system.

8. Never Over-Tighten Fittings

 One of the most common mistakes when it comes to plumbing is over-torquing fittings (just as in riding a bike). A common scenario is fittings that are turned 100%, then when tightened up 80% are required. There are other occasions when fittings turn in reverse. Another example that can occur is a fitting turning 90 degrees, then when fully tightened will only require 75% torque. We often see situations where a 90 degree fitting has been turned 90 degrees, then 90 degrees the other way, then 90 degrees the other way and finally fully tightened. This kind of scenario can be avoided by always setting your torque to 75%.

9. Make Friends with Plumber’s Tape

 Plumbers tape is one of those things that seem indispensable – but how often do you actually use it? If the only time you ever see plumber’s tape is when you need to change a leaky faucet, it may be time to befriend it. Following some basic tip and trick can help you save money around the house and get a few more uses out of the plumber’s tape you have.

10. Always Check for Leaks

 One of the easiest ways to save money on your water bill is to make sure you’re not wasting any. When you check for leaks, you’ll find that most of your usage comes from things that shouldn’t go down the drain. That’s because your toilet tank and shower head are the largest users of water in your home.


Whether you’re a homeowner or renter, you never know when you’ll need a plumber. That’s why it’s always a good idea to brush up on your plumbing knowledge. Check out my list of the top 10 plumbing tips everyone needs to know. And if you have any plumbing questions, feel free to ask me in the comments! Thanks for reading, and I look forward to hearing from you!

Leave a Reply